用途：

我司生产的除湿机被塑胶加工所广泛适用。而吸湿性强的PA、PC、PET、PETG、ABS等工程塑胶料已被证明受其周围环境条件影响较大，无法用传统的热风干燥系统来有效的降低其含湿率。这些吸湿性极强的工程塑料必须在成型前，采用稳定高的低露点干燥风（至少-32℃）搭配适当的干燥温度才能保证最终含湿率降到0.02％以下，一旦此条件达成，该类塑胶成型品便能展现其最佳物理性质及表面光度，有效率的除湿干燥机，由于其密闭循环系统加上可以低到-50℃以下的低露点干燥风能促使塑料快速释放水份至干燥风，更可以帮助成型业者避免成型出项缩水，银纹或凹痕等状况。

特点：

1.      高效能（採用日本Nichias除濕用蜂巢轉輪）。

2.      可獲得超低溫（低露點）的空氣。

3.      容易從高溫空氣仲除濕（與其它的吸濕劑不同，在100℃時吸附能力也良好。

4.      低溫的空氣也可除濕。（在低溫度高壓等的空氣中，吸濕力高，可獲得超低溫空氣）

5.      維護簡單。

6.      可用水清洗。（附著灰塵時用水清洗後可再使用）

KNDD Series Honeycomb Type Dehumidifier

Main application:

At present, engineering plastics such as Nylon, PC, PET are widely used in plastic processing and its strong hygroscopicity that are proved to involve in the weather, can not be reduced effectively by the traditional heated air drying system. Before molding, it must adopt the high stability low dew point dry wind (at least -32℃) and appropriate dry temperature to realize its moisture content below 0.02%. In this condition, the formed plastics can show its best physical property and perfect. The efficient dehumidifying-drying machine for its closed cycle system and below -50℃low dew point dry wind can make the plastics release the moisture rapidly to the dry wind and can avoid the formed ones from shrinking crazing or dent.

Features：

1. High performance with Japanese Nichias honeycomb rotating wheel for dehumidification

2. Ability to get the ultra low temperature (low dew point) air

3. Easy to absorb the moisture in the hot air (Different from the other adsorbents, its adsorptive capacity can be well at100℃).

4. Ability to absorb moisture of low temperature air(Low temperature air, such as high pressure air, the good moisture absorbance can make the ultra low temperature air.)

5. Easy maintenance

6. Ability to wash in the water .It can be used again after wash to remove the gray scale.